J-B Weld ExtremeHeat Metallic Repair Paste 85.2g
Find it in store:
Deliver to:
Auckland 1026,
NZ
Estimated:
$5.99
2-hour Click & Collect:
(order before 3pm, in-stock products only)
Our Auckland Shop
Free
Buy Now, Pay Later with
Find Local Store
Buy Now Pay Later with Afterpay. Available for purchases between $99 and $2000.
QCard No payments or interest for 12 months*
Minimum spend $200. Lending criteria, $50 annual Account Fee, fees, Ts&Cs apply. At end of interest free period, Q Mastercard Expired Promotional Rate or Q Card Standard Interest Rate of 28.95% p.a. applies (see Ts&Cs for Q Mastercard Standard Interest Rate). $55 Establishment Fee or $35 Advance Fee applies.
*See here for full T&C
Report incorrect product information
Temperature-resistant metallic paste
The J-B Weld ExtremeHeat Metallic Repair Paste is formulated to allow for repairs to iron, steel and metal in high temperature environments (1000°F / 538°C). When fully cured, this metallic compound can be drilled, machined or sanded. It is great for repairing cracks, small gaps, seam connections or holes in exhaust manifolds, pipe connections, mufflers, catalytic converters, outdoor grills, fire boxes, gas and commercial furnaces and water heaters. This product is water based, non-flammable and contains no solvents or Volatile Organic Compounds (VOCs).
J-B Weld ExtremeHeat Metallic Repair Paste Features:
- Set Time: 1 Hour
- Cure Time: 24 Hours
- Able to withstand continuous heat (1000°F / 538°C)
- Cure Colour: Machine Grey
Applications:
- Exhaust Manifolds
- Tail Pipes
- Mufflers
- Engine Blocks
- Duct Work
- Heat Exchange Units
- Fire Box / Fire Place
- Outdoor Grills
Instructions:
- Prepare: Remove dirt, debris or loose contaminants from surface. Use sand paper to roughen. For some repairs, open small cracks further with a drill or screwdriver to create a 1/8in gap.
- Open J-B Weld Extreme Heat. Thoroughly mix product.
- Apply: Use product generously, working onto surface or into hole, crack, pit or seam. Repeat as needed. Allow 2-4 hours set up, depending on temperature and current environment.
- Dry: Test cure by pressing fingernail or thumbnail into repair material. If unable to penetrate, then repair is complete. If area appears slightly soft, use a non-flame heat source, such as a hair dryer, to speed cure time, or allow 24 hours before allowing high heat exposure. Repeat test until fully cured.
Some of our product deals are strictly limited - once they're gone, they're gone! Secure yourself this amazing deal while stocks last...by clicking the Add to Order button above.