J-B Weld Ultimate Black RTV Silicone Gasket Maker and Sealant
Buy Now, Pay Later with
Find Local Store
Minimum spend $200. Lending criteria, $50 annual Account Fee, fees, Ts&Cs apply. At end of interest free period, Q Mastercard Expired Promotional Rate or Q Card Standard Interest Rate of 28.95% p.a. applies (see Ts&Cs for Q Mastercard Standard Interest Rate). $55 Establishment Fee or $35 Advance Fee applies.
*See here for full T&C
J-B Weld Ultimate Black Gasket Maker and Sealant is an RTV (Room Temperature Vulcanised) Silicone gasketing material designed for use in mechanical assemblies where maximum petroleum and oil resistance is required. Upon curing, which occurs when the product is exposed to the moisture in air, the silicone forms a tough, waterproof, gasket and seal on most surfaces. It will not shrink or crack, resists oil and petroleum products, resists weathering, is sensor safe, has good temperature resistance up to 500 F intermittent and is great for many automotive applications.
Features:- Maximum Oil Resistance
- Temperature Resistant up to 500 degrees F
- Low Odour
- Sensor Safe
- Set Time: 1 Hour
- Cure Colour: Black
Applications:
- Oil Pans
- Valve Covers
- Transmission Pans
- Timing Gear Covers
Instructions:
- Prepare: For best results, clean and dry surface area
- Apply: Apply even, continuous 1/4 inch bead of Silicone to one surface area. Surround all bolt holes with Silicone.
- Assemble: Reconnect parts while Silicone is wet.
- Secure: Hand tighten until Silicone begins to squeeze out.
- Dry: Allow drying for 1 hour and then tighten an additional 1/2 turn.
- Finish: Scrape or cut away excess cured sealant. Silicone will fully cure in 24 hours.