Pestrol Solar Waterproof 360-Degree Pest / Bird Deterrent

Protects against invading animals, birds & rodents from all directions

• Alarm/Ultrasonic/LED lights – This mode will deter all animals and birds – Green indicator light is on
• Ultrasonic/LED Lights – This mode will deter mainly animals, however, birds will be deterred by the bright flashing LED lights – Green indicator light off

1. Hold down the power button to turn on the unit.
2. The repeller will activate if the PIR motion sensor detects animal movement. If there are no animals in the detection area, the repeller will remain on standby mode.
3. No matter which direction the animal comes from, they will be detected by one of the 3 PIR sensors.
4. The Repeller will start to work automatically by flashing LED lights, emitting ultrasonic sound (15-50kHz frequency) and an alarm sound. (The alarm sound can be turned off as required)
5. By default, the blue light and alarm sound is switched on, this can be turned on/off by pressing the respective buttons.
6. To turn off the blue light, press the button “Power/Blue Light” once, then the blue light will be turned off. If you want to turn the blue light on again, press the button again. In the evening the blue light can’t be turned off.
7. To turn off the alarm sound, press the button “Sound” once, the alarm sound will be turned off in the next cycle. If you want to turn on the alarm sound again, press the “Sound” button once. Note: When the alarm sound is on, the green indicator light is on and when the alarm sound is off, there is no green indicator light.

• Provides 360-degree protection against invading animals and birds from all directions
• USB and solar charge
• Smart design with PIR sensors
• 2 flashing LED lights
• Ultrasonic speakers on each side (15-50kHz frequency)
• 3 side speakers working independently
• Waterproof IP44 design
• Motion detection (10m range)
• Bright white LED lights
• High-frequency sound
• Sound alarm
• Goes into standby mode 10 seconds after the animals leave, so as to keep energy use low

• Before installation, please charge the repeller under direct sunlight for 12 hours or charge via USB for 4 hours. One of the PIR sensors will turn red when charging.
• Assemble the poles one by one using the supplied connectors.
• Turn on the unit by holding down the Power/Blue Light button for 2 seconds. It will go through a self-check mode briefly then the unit is ready to go.
• Connect the repeller to the pole and push the pole into the ground.

• Please install the repeller in a sunny location.
• If there is not enough sunshine, charge the repeller via the USB cable.
• For better results keep the head of the repeller 20 cm above the ground.
• Do not cover the PIR sensor, otherwise, the repeller will not work.
• Keep the repeller away from your children and pets.
• The repeller does not work while charging with the USB.