CruzPro T-65 Temperature Gauge for Three Areas

#9091023
Warranty Badge - 12-Months
Ships May 10 - May 15
ONLY $529.00

Seen a lower price? Ask us to beat it

Add Items to Cart
No payments or interest for 12 months*

Click on the image above to view full picture

The item you're looking at is currently unavailable or has limited stock, how about this one instead?
Details

Details

The CruzPro T65 digital temperature display continuously monitors three separate sensors and displays temperature from -20 deg F (-29 deg C) to +140 deg F. (+60 deg C).

You can simultaneously monitor three zones such as bait tanks, engine room temperature, refrigerators, freezers, sea water temperature, inside cabin temperature, outside temperature, fish holds, battery temperatures, etc.

Individual high and low alarms can be set for each area. When activated, the built-in 85dB alarm buzzer will sound and the display will flash.

The T65 is factory calibrated but can be user calibrated in the field for each individual sensor for spot-on accuracy. All set-up and calibration constants are saved to non-volatile memory

The T65 uses standard 10K NTC thermister temperature sensors (the type most often used in speed/temperature and depth/temperature transducers). Bronze thru-hull, plastic transom mount and zinc plated bolt-on temperature transducers are available separately.

Five-level red backlighting for easy night-time viewing.

Works on both 12 and 24 VDC systems.

Very easy to install, requiring only a 2-1/8inch (55mm) hole saw and screwdriver to connect.

Outputs a separate NMEA 0183 serial data sentences for each temperature zone at 4800 BAUD on rear screw terminal pin.

Specifications:
  • Operating Voltage: 9.5 - 33.0 VDC
  • Current Drain: 0.018 amps nominal
  • Display: 4 digit LCD, red LED backlighting
  • Range: -20 deg F (-29 deg C) to +140 deg F (+60 deg C)
  • Accuracy: +/- 1 deg F or C (settable by user)
  • Senders: Standard 10Kohm NTC thermister. Both bronze and plastic senders available separately.
  • Alarms: Built-in 85dB alarm, individually settable high and low alarms for each of the three areas. IF NMEA 0183 serial data is not required, this output terminal may be user programmed as an external alarm output.
  • Data Output: NMEA 0183 serial 4800 BAUD, a separate $IIXDR NMEA 0183 sentence for each area
  • Size: 2.5'' dia X 4.1'' deep (61mm x 104mm)
  • Mounting: 2-1/8'' (55mm) round hole

Connection Diagram:



User Manual

Products You Recently Viewed

Recently Viewed